DIY Fabric Pin Board using a Picture Frame | kzvDIY

DIY Fabric Pin Board using a Picture Frame | kzvDIY


Hey guys! I made this pin board for my
daughter and she absolutely loves it! Keep watching and I’ll show you how I
put this together! Let me show you all the materials that I used to make this
pin board The first thing I’m going to do is
remove the glass from the frame and safely dispose it since we won’t need it.
Keep in mind that you can purchase any new frame to do this, but if you are
going to use an old frame that you already have just make sure it still has
the backing to it The next thing I want to do is cut the
cork material so that it fits inside the frame. To do that I’m
going to take the backing of the frame, place it on top of the piece of cork and
then trace it Okay, so now that I have my piece of cork
cut out I’m going to hot glue it to the mat board. I’m going to do this so that
the cork material will be nice and flat this will make it easier for me to lay
the fabric on later. If you’re using a frame that doesn’t have a mat board
don’t worry you can use the back board which is also known as the backing of
the frame Next I want to cut out my fabric to make
sure I have enough fabric but not too much. I’m taking the back board and
placing it on top of the fabric and cutting off any extra Okay, so here I have my fabric that I cut
out earlier, a foam brush, and modge podge This is the step where I’m going to
modge podge the fabric with the cork material. Doing this will bond the two
together nicely. To make sure I only apply the modge podge where it is needed
I’m going to take my piece of cork, set it on top of the back of the fabric and
trace, then apply my modge podge Now I’m taking my Mod Podge and I’m
going to apply it only in the section that I traced because that’s where my
cork is going to be placed on, it’s going to be placed on top of the modge podge After placing my piece of cork on top of
the modge podge now I’m going to take the fabric on the sides and hot glue
them to the mat board. I’m doing this so that the extra fabric is secured in
place and is not hanging out or in the way As you can see here I’ve placed my
fabric covered cork inside my frame. Now I’m just going to take the back board and
secure the frame just like how you would if you were securing a photo The last thing I’m doing here is just
smoothing it out and making sure that everything is in place. So here is the
finished product! Give it a try and let me know how it goes!
Thanks for watching guys!

Leave a Reply

Your email address will not be published. Required fields are marked *