How to Make a Goblin Halloween Costume : Adding Liquid Latex for Goblin Halloween Costumes

How to Make a Goblin Halloween Costume : Adding Liquid Latex for Goblin Halloween Costumes


Hi, I’m Matt Cail and on behalf of Expert
Village I’m going to show you how to make a goblin costume. As we are moving onto the
makeup and effects we are going to be doing on our face make sure and put on the black
robe. It’s awful to do a great makeup job then all of the sudden you realize wait I
have to put a black robe all over it and you are going to smear. It’s going to be a mess.
So make sure and get the black robe on before we go onto our next first step on applying
makeup to the face which is going to be some liquid latex. We are going to be applying
liquid latex in several steps as we build up our goblins face. The first thing we are
going to do is start applying a line of it underneath the eyes. Now important safety
tip. Don’t get the liquid latex close to the eye. You can see basically I’m on the upper
part of the cheekbone and that’s as close to the eye as I’m going to get for today.
Now the other big trap not to fall into is try not to make straight lines. This should
look more ragged and not have a lot of straight lines. At the same time don’t get, don’t paint
too broad of stroke either. So make sure and definitely find that balance. You are going
to need three to four minutes for this to dry each time and then after that you are
probably going to apply a couple of different layers as we move on.

9 Replies to “How to Make a Goblin Halloween Costume : Adding Liquid Latex for Goblin Halloween Costumes”

  1. hey, i just bought about 30 bottles of Mold Builder, and i was reading the container and it said it contained Ammonia (100% to be exact), and that it was dangerous to use on skin, and now im highly disapointed, because This is the only stuff i can find, and i dont have enough time to order it online. All i want to know is if this stuff is dangerous to inhale or to use on skin.

Leave a Reply

Your email address will not be published. Required fields are marked *